Information & Specifications Suggested Railing Framework
Basic Framework
END POST END POST
U P T O 5 0 F T. W / C L A S S I C S E R I E S U P T O 2 5 F T. W / S M O O T H L I N E , T E R M I N AT O R S & D E C K O S E R I E S
11 9 7 5 3

The following is only a guide line. Please check your local building code for use of cable rails.

3" - SPACING

1 2 4 6 8 10 12

Recommended Cable Tensioning Sequence

INTERMEDIATE POST

UP TO 4 FT.

Framework:
End posts and corners need to be made from the following minimums: * Round Pipe 1-1/2" ID Schedule 80 * Square Tube 2" X 2" X 1/4" Wall * Angle Iron 2" X 2" X 1/2" * Flat Bar 2" X 1" * Wood Post 6" X 6" Please Note: Johnson Architectural Hardware does not make framework. Framework needs to be made by a steel fabricator.

Technical Support - Call 1.800.874.7455
OK, you want cable railings, but you do not have time to read the catalog. Please call us toll-free at 1.800.874.7455. Johnson Architectural will talk you through the process and make sure you get the help you need. If you are a contractor or steel fabricator, call us to walk you through the HAND CRIMP cable process. If you are a licensed contractor or steel fabricator, Johnson Architectural can sell you HAND CRIMP hardware direct. MACHINE SWAGE fittings are only sold to authorized riggers with Mil-Spec swage equipment. If you need machine swage CABLE ASSEMBLIES, please call us for the name and number of a rigger near you. Good luck with your cable project.

Johnson Architectural * Tel 800.874.7455 * Fax 860.873.8589 * www.csjohnson.com

9