Miscellaneous Architectural Hardware Arbor Clip
The Arbor Clip fitting allows you to attach 1/8" and 3/16" cable at 90 intersections for constructing garden arbors and decorative walls. Arbor Clips are constructed with a threaded hole all the way through for fastening the cable and attaching the backside to supportive wall studs.
CAT. NO. 62-500 62-505 WIRE SIZE 1/8" 3/16"

Glass Shelf Fittings
The Glass Shelf Fitting works on 1/8" wire and 3/8" thick glass. The Glass Shelf Fittings make it easy to make glass shelves with cable and glass for a unique look. Johnson does not sell glass.

5/8" 3/8"
1 1/4"

CAT. NO. 62-100

WIRE SIZE 1/8"

GLASS SIZE 3/8"

Glass Shelf Fitting used on Bar Shelf.

Glass Shelf Fitting with 1/8" Deck Toggle Terminator.

28

Johnson Architectural * Tel 800.874.7455 * Fax 860.873.8589 * www.csjohnson.com

"Smart Catch" Stainless Spring-Loaded Door Latch
This unique Door Latch is a design that not only serves as a door stop, but holds the door in place against a wall. The unique foot lever releases the spring-loaded bumper and swings the door free. Two styles are available -- straight or pivot, for non-parallel closing doors.

CAT. NO. 48-800

DESCRIPTION "Smart Catch" Door Latch - Straight "Smart Catch" Door Latch - Pivot

Vertical Rods

48-801

Johnson's 1/4" stainless steel vertical rods are an excellent choice for vertical railings. The 1/4" rods need to be placed every three inches to satisfy code requirements. Held in place at the top with Johnson's Button End Cap, the rod is tensioned at the bottom with 1/4" x 28 thread. A wrench flat is provided at the bottom to rotate the rod tight. The rods can be threaded directly into the railing or held with a conventional nut and washer. A steel fabricator must provide a framework and cap rail for the rods. Additional sizes available, please call for more information.

B a l l T o p

B u t t o n T o p

Framework
End posts and corners need to be made from the following minimums: * Round Pipe 1-1/2" ID Schedule 80 * Square Tube 2" X 2" X 1/4" Wall * Angle Iron 2" X 2" X 1/2" * Flat Bar 2" X 1" Top and bottom horizontal channels to support rods need to be made from: * 1" x 1" x 1/8" Channel and supported every 4 feet by the end posts listed above. * 3/4" OD x 1/4" Pipe center post needs to be placed every 2 feet.
Please Note: Johnson Architectural Hardware does not make framework. Framework needs to be made by a steel fabricator

4' Rod Rail Panel Example

Johnson Architectural * Tel 800.874.7455 * Fax 860.873.8589 * www.csjohnson.com

29